Sensorless Dc Control Pairing Procedures; Operating Instructions - Kichler 300370 Manual De Instrucciones

SENSORLESS DC CONTROL PAIRING PROCEDURES

IMPORTANT: Ceiling fan blades MUST be installed before pairing procedure can begin.
Step 1. Press the power button "
circuit at the circuit breaker or fuse box. Within 60 seconds of turning on the power, press the "
control (the button will be down) and then press the "
time, the fan will run for a while and then stop. The remote will now be programmed to your fan and ready for use.
IMPORTANT: Do not press any buttons on the remote until after the pairing process is complete. Wait until after the fan has come to a
complete stop.
Step 2. Try different speed settings on the wall control to ensure the fan is now fully functional. If programming is unsuccessful, retry the
process starting from step 1 again.
OPERATING INSTRUCTION
Press the power button "
To set the desired fan speed, press and hold the "
increase the speed. (Fig. 26)
To turn the light on and off, press and release the light "
intensity, press and hold the light button. The light will turn on at the light intensity
previously selected. (Fig. 26)
18 | KICHLER.COM
" to turn off the wall control (the button will be up). Restore electricity to the ceiling fan branch
" reverse button for 3 to 5 seconds. The light will flash twice, and at the same
"once to turn ON (or OFF) the fan. (Fig. 26)
" button to decrease and
" button. To set the light
" power button to turn on the wall
Indication Light
(Power)
Fig.26
Airflow Direction
Light Button
Fan Speed Button
Power Button