Safety Instructions - Forward Lift MCH13 Guía De Instalación, Operación Y Mantenimiento

• Inspect your lift daily. Never operate if it malfunctions
or if it has broken or damaged parts. Use only qualified
lift service personnel and Genuine OEM Parts to make
repairs.
• Thoroughly train all employees in use and care of lift,
using manufacturer's instructions and "Lifting It Right" and
"Safety Instructions" supplied with the lift.
• Never allow unauthorized or untrained persons to
position vehicle/lift or operate lift.
• Prohibit unauthorized persons from being in shop area
while lift is in use.
• Do Not permit anyone on lift or inside vehicle when it is
either being raised or lowered.
• Do Not operate lift while batteries are charging.
• Always keep area around lift free of tools, debris, grease
and oil.
• Never Overload lift. Capacity of lift is shown on
nameplate affixed to the lift.
• Do Not hit or run over lift forks or base. This could
damage lift or vehicle. Before driving vehicle into area,
position lift units to provide unobstructed entrance onto
lift area.
• Load vehicle on lift carefully. Position lift forks to fully
contact the vehicle tires. Release parking brake on
vehicle. Raise lift until tires clear the floor. Check lift
forks for secure contact with vehicle tires. Raise lift to
desired working height.
• Do Not block open or override self-closing lift controls,
they are designed to return to the Off or Neutral position
when released.
• Remain clear of lift and vehicle when lowering.
• Avoid excessive rocking of vehicle while on lift.
• Clear area if vehicle is in danger of falling.
• Remove tool trays, stands, etc. before lowering lift.
• Position lift units to provide an unobstructed exit before
removing vehicle from lift area.

SAFETY INSTRUCTIONS

• Do Not perform any maintenance on the control panels
until the power has been shut off to the lift.
• Do Not operate equipment with a damaged cord or if the
equipment has been dropped or damaged.
• Lift operates at a sound level of approx. 80db(A).
• Do Not drive over pendant.
• Never use remote controller below floor grade.
• Always lower columns onto the locking latches.
• Confirm all lift channels match before operating lift.
• For proper operation, the lift must be operated in
multiples of 2. Never operate with an odd number of
columns.
4