SURE petcare SureFeed Microchip Pet Feeder Connect Manual Del Usuario página 7

Batteries
Always use 4 x good quality 1.5V LR14 alkaline C cell batteries. This will ensure the best
performance of your Microchip Pet Feeder Connect. This product is NOT designed for use with
rechargeable batteries. To insert or change the batteries please follow the steps below:
There is a light near the rear of the feeder. If the batteries are low, or if there's
a problem with how they've been inserted, this light will flash red every five seconds.
1
Turn the feeder upside down to access
the battery compartments.
3
+
–
Insert the batteries. Ensure the +/- symbols
on the batteries match the symbols on
the feeder itself.
Once you program your pet's microchip ID into the feeder it will be permanently
stored in its memory. This means that even when you change the batteries,
the feeder will still recognise your authorised pet.
11
2
Remove the battery covers.
4
+
–
Replace the battery covers.
Connect your feeder
In order to complete the setup of your connected system, you need to connect your feeder
to your household.
1 2
Place your feeder in its On the Sure Petcare App,
intended location. This is to select 'Add product'.
ensure it can communicate
with the Hub.
4 5
Once the feeder is
Press the settings button ' '
connected the LED
on the feeder once. The ear
will turn off and the Hub
LED will illuminate green.
will stop flashing.
Adding a feeder to your current household
You can add a Microchip Pet Feeder Connect to your existing Sure Petcare
Household via the app. Go to the household section and follow the
instructions above.
You can also assign your pet's microchip ID remotely via the app. This means
you won't have to add them manually. However, adding pets using treats can
encourage them to use the new product. See page 15 for more information
on adding pets.
EN
3
Your Hub will go into
connecting mode and
its ears will flash green.
30cm
If you wish to connect more
feeders, you can do this easily
from within the app.
12