Descargar Imprimir esta página

Nilfisk Liberty SC60 Instrucciones De Uso página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARE THE MACHINE FOR USE
BATTERIES
If this machine shipped with batteries installed do the following:
Check that the batteries are connected to the machine (39).
Turn ON the Key Switch (27) to power ON machine and check the Battery Indicator (O). If the gauge is completely filled the batteries are ready for use. If
the gauge is less than full the batteries should be charged before use. See the "Charging the Batteries" section.
IMPORTANT!: REFER TO THE BATTERY CHARGER'S OEM PRODUCT MANUAL FOR INSTRUCTIONS REGARDING SETTING THE CHARGER FOR
BATTERY TYPE.
If this machine shipped without batteries installed do the following:
Consult an Authorized Nilfisk dealer for recommended batteries.
Install the batteries by following the instructions below.
IMPORTANT!: REFER TO THE BATTERY CHARGER'S OEM PRODUCT MANUAL FOR INSTRUCTIONS REGARDING SETTING THE CHARGER FOR
BATTERY TYPE.
INSTALL THE BATTERIES
WARNING !
Use extreme caution when working with batteries. Sulfuric acid in batteries can cause severe injury if allowed to contact the skin
or eyes. Explosive hydrogen gas is vented from inside the batteries through openings in the battery caps. This gas can be ignited
by any electrical arc, spark or flame. If battery acid makes contact with your skin or eyes, flush the affected area with water for 5
minutes and seek medical attention.
When Servicing Batteries...
Remove all jewelry to avoid accidental shorts.
Do not smoke.
Wear safety glasses, a rubber apron and rubber gloves.
Work in a well-ventilated area.
Do not allow tools to touch more than one battery terminal at a time.
ALWAYS disconnect the negative (ground) cable first when replacing batteries to prevent sparks.
ALWAYS connect the negative cable last when installing batteries.
CAUTION !
Electrical components in this machine can be severely damaged if the batteries are not installed and connected properly. Batteries
should be installed by Nilfisk or by a qualified electrician.
Only batteries approved for use in this machine by Nilfisk shall be installed.
1
Remove the batteries from their shipping crate and carefully inspect them for cracks
or other damage. If damage is evident, contact the carrier that delivered them or the
battery manufacturer to file a damage claim.
2
Turn the Key Switch (27) off (O) and remove the key.
Tip the seat forward to open the Battery Compartment (10).and set the prop rod.
3
4
Using (2) people and an appropriate lifting strap, carefully lift the batteries into the
compartment tray exactly as shown. Refer to the battery wiring decal 56123085 on
the underside of the seat panel.
5
See Figure 2-1. Install battery cables as shown and carefully tighten the nut in
each battery terminal until the battery cable will not rotate. Do not over-tighten the
terminals, or they will be very difficult to remove for future service.
6
Install the battery boots and secure tightly to the battery cables with the supplied tie
straps.
7
Connect the battery pack connector to the Machine Battery Connector (39) and close
the battery compartment cover.
When changing batteries or the charger, please contact a local authorized service
center for correct battery, charger and machine settings to prevent battery damage.
11/2020
INSTRUCTIONS FOR USE
FIGURE 2-1
24V
56091234 - Nilfisk Liberty SC60
ENGLISH - A
390A/H
A - 13

Publicidad

loading