Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL THE BRUSHES (DISC SYSTEM)
1
Verify which brush or pad is appropriate for the floor surface to be cleaned.
2
Make sure the Scrub Deck (8) is in the RAISED position. Make sure the Key Switch (27) is off.
CAUTION !
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1
Make sure the Scrub Deck is in the RAISED position. Make sure the Key Switch (27) is in the OFF position (O).
2
See Figure 2-4. Remove both side blade assemblies. NOTE: The blade assemblies are held in place by two large Knobs (AA). Loosen
these knobs and slide the Side Blade Assemblies (AB) slightly forward and then off the Scrub Deck.
3
To install the Brushes (AC) (or pad holders) align the Lugs (AD) on the brush with the holes on the mounting plate and turn to lock in place
(turn the outside edge of brush towards the front of machine as shown by arrow (AE)). NOTE: While scrubbing the brushes rotate in the
direction as shown by arrow (AF).
FIGURE 2-4
AUTOMATIC BRUSH REMOVAL (DISC SYSTEM)
1
Turn the Key Switch (27) to the ON position (I). Wait for initial start up screen.
2
Make sure the Scrub Deck (8) is in the RAISED position.
Press and hold both Scrub Pressure Decrease Switch (A-) and Scrub Pressure Increase Switch (A+) for 3 seconds.
3
4
Brushes will begin to spin then stop abruptly and drop off of the scrub deck.
A-
11/2020
AF
AE
INSTRUCTIONS FOR USE
AF
56091234 - Nilfisk Liberty SC60
ENGLISH - A
AA
AB
AD
AC
A+
A - 15
Publicidad
