Descargar Imprimir esta página

Nilfisk Liberty SC60 Instrucciones De Uso página 29

Publicidad

Idiomas disponibles

Idiomas disponibles

TEACH ROUTE FOR AUTONOMOUS MODE - CONTINUED
7
Begin to drive the machine along the route's path.
a. Touchscreen will display the machine is "Learning...".
8
Clean the area using the desired vacuum, solution, scrub and
detergent settings.
- While teaching Route;
a. Operate all of the scrub functions. Clean the floor as if in
manual mode. See section "OPERATING THE MACHINE
MANUAL MODE" for more information on adjusting any of the
scrub settings.
NOTE: Because scrubbing requirements can change from
day to day the scrub settings are not recorded at the time of
teaching and will be set at the time of running the route.
b. When scrub is turned ON or OFF will be recorded along with
the route traveled.
c. If machine is driven without turning scrub ON while teaching,
the route will be saved without scrubbing. Scrub ON/OFF can
not be added later to the route. Scrub settings (scrub pressure,
solution flow etc.) can be set after training the route.
d. The machine speed (including stops) and operator's use of the
horn is not recorded while teaching, just the route.
e. The reverse switch is not selectable while teaching so plan
route in advance to avoid backing up.
9
Stopping the machine while teaching brings up a "Learning Paused"
screen. The operator has three options;
a. Drive to continue teaching route.
b. Press "Cancel" to delete the route without saving. Display
allows to confirm Cancel or Resume (exit cancel).
c. Press "Save" to save the new route.
11/2020
INSTRUCTIONS FOR USE
56091234 - Nilfisk Liberty SC60
ENGLISH - A
A - 29

Publicidad

loading