Nilfisk Liberty SC60 Instrucciones De Uso página 20

A - ENGLISH
DETERGENT SYSTEM USE (ECOFLEX)
Detergent Ratio (SCRUB AND SOLUTION SYSTEM MUST BE ON):
No detergent is dispensed until the scrub and detergent systems are activated, direction is set to forward (Reverse Indicator (L1) not lit), and the
Drive Pedal (3) is pressed.
• The Detergent Mode Indicators (C1) will light up when the detergent system is on.
• The three lights signify the selected ratio/percentage of detergent.
There are 5 modes of EcoFlex operation:
1. Chemical Free Cleaning Mode - During scrubbing, the detergent system can be turned off at any time by pressing the Detergent Mode
Decrease Switch (C-) until all Indicators (C1) are off, to allow scrubbing with water only.
2. Detergent Low Mode – Activated by pressing the Detergent Mode Increase Switch (C+) when detergent is off (repeated presses will
increase to Medium Mode and High Mode, press Decrease Switch (C-) to return to low mode).
• The first Detergent Mode Indicator (C1) will be lit.
• Detergent = 0.3% / 3 ml/Liter / 1:300 Ratio
3. Detergent Medium Mode – Activated by pressing the Detergent Mode Increase Switch (C+) when detergent is in Low Mode (additional
presses will increase to High Mode, press Decrease Switch (C-) to return to medium mode).
• The first and second Detergent Mode Indicators (C1) will be lit.
• Detergent = 1.0% / 10 ml/Liter / 1:100 Ratio
4. Detergent High Mode – Activated by pressing the Detergent Mode Increase Switch (C+) when detergent is in Medium Mode (pressing
Decrease Switch (C-) will decrease mode to medium then low).
• All three Detergent Mode Indicators (C1) will be lit.
• Detergent = 3.0% / 30 ml/Liter / 1:32 Ratio
5. Burst of Power Cleaning Mode – Press the Burst of Power Switch (D) to enter Burst of Power mode. Burst of Power Indicator (D1) will blink
for one minute. Press Switch (D) again before 60 seconds to cancel Burst of Power.
• Detergent ratio will increase to the next higher concentration detergent level. Detergent system will be turned ON at "detergent low
mode" if it was OFF.
• Solution flow rate will increase to the next higher level, visible at (B1).
• Scrub pressure will increase to the next level, visible at (A1).
• Vacuum power will have no change. If the vacuum system is off then it will remain off.
Once set, the detergent flow rate automatically increases and decreases with the solution flow rate, but the detergent ratio/percentage remains the
same.
A - 20
INSTRUCTIONS FOR USE
Nilfisk Liberty SC60 - 56091234 11/2020