Toshiba RAV-GM901BTP-E Manual De Instalación página 10

Installation of hanging bolt
Consider the piping / wiring after the unit is hung to
determine the location of the indoor unit installation
and orientation.
After the location of the indoor unit installation has
been determined, install hanging bolts.
For the dimensions of the hanging bolt pitches, refer
to the external view.
When a ceiling already exists, lay the drain pipe,
refrigerant pipe, control wires, and remote controller
wires to their connection locations before hanging
the indoor unit.
Procure hanging bolts washer and nuts for installing
the indoor unit (these are not supplied).
Hanging bolt M10 or W3/8 4 pieces
Nut M10 or W3/8 12 pieces
Washer M10 8 pieces
Installation of hanging bolt
Use M10 hanging bolts (4 pcs, locally procured).
Matching to the existing structure, set pitch according
to size in the unit external view as shown below.
New concrete slab
Install the bolts with insert brackets or anchor bolts.
Rubber
Anchor bolt
(Blade type (Slide type
(Pipe hanging
bracket)
bracket)
anchor bolt)
Steel frame structure
Use existing angles or install new support angles.
Hanging bolt
Support angle
Hanging bolt
Existing concrete slab
Use a hole-in anchors, hole-in plugs, or a hole-in bolts.
17-EN
Installation of indoor unit
Treatment of ceiling
The ceiling differs according to structure of building.
For details, consult your constructor or interior finish
contractor.
In the process after the ceiling board has been
removed, it is important to reinforce ceiling foundation
(frame) and to keep horizontal level of installed ceiling
correctly in order to prevent vibration of ceiling board.
Attach the nuts and the M10 flat washers to the
hanging bolt.
Put washers at up and down of the hanging bracket
of the indoor unit to hang down the indoor unit.
Check that four sides are horizontal with a level
gauge. (Horizontal degree: Within 5 mm)
Hanging bolt
M10 fl at washer
(W3/8 or M10)
Nut
(W3/8 or M10)
M10 fl at washer
Nut
(W3/8 or M10)
REQUIREMENT
Hang the unit in a horizontal position.
When unit is hanged to slant, it may cause
overflow of drainage.
Install the unit within the dimension according to
the figure below.
Use level gauge to confirm whether the unit is
hang horizontally.
Front view
Set the drain pipe connecting
port side within 5 mm lower than
opposite side.
Side view
Set the air intake and air
discharge sides are within 5 mm
with each other.
– 9 –
Mounting fi lter rails and fi lters
1
Mount the fi lter rail so that the hooks fi t into the corresponding holes.
(Note that the upper and lower fi lter rails are not identical.)
2
Mount the fi lter stopper.
* When mounting the rails, push them until the
3 latches click.
3
Slide and push the fi lters until it stop.
* Insert the fi lters into the direction which the
arrows, carved on the fi lters, show.
(2 fi lters are identical)
Changing from back air intake to under air intake
1
Remove the fi lters on back of unit.
2
Remove the suction board cover attached to the bottom, and screw it to the back of unit.
3
Mount the supplied rail to the bottom, then set the fi lter.
Suction board cover
Screw
Suction board cover
Upper fi lter rail Square hole
Fit this hook into
the square hole.
Filter stopper (accessory)
Lower fi lter rail
Suction board cover
Hook part
Hook part
Screw
Suction board cover
18-EN