Toshiba RAV-GM901BTP-E Manual De Instalación página 11

5
Drain piping
CAUTION
Following the Installation Manual, perform the drain piping work so that water is properly drained. Apply a
heat insulation so as not to cause a dew condensation.
Inappropriate piping work may result in water leakage in the room and wet furniture.
Provide the indoor drain piping with proper heat insulation.
Provide the area where the pipe connects to the indoor unit with proper heat insulation. Improper heat insulation
will cause condensation to form.
The drain pipe must be sloping downward (at an angle of 1/100 or more), and do not run the pipe up and down
(arched shape) or allow it to form traps. Doing so may cause abnormal sounds.
Restrict the length of the traversing drain pipe to 20 meters or less. For a long pipe, provide support brackets at
intervals of 1.5 to 2 meters to prevent flapping.
Install the collective piping as shown in the following figure.
Do not provide any air vents. Otherwise, the drain water will spout, causing water to leak.
Do not allow any force to be applied to the connection area with the drain pipe.
Support
bracket
1.5 m to 2 m
(Collective
piping)
Heat insulator
Downward slope
1/100 or more
Pipe material, size and insulator
The following materials for piping work and insulating process are locally procured.
Pipe material Hard vinyl chloride pipe VP25 (Nominal outer diameter Ø32 mm)
Insulator Foamed polyethylene foam, thickness: 10 mm or more
Connecting drain pipe
Insert flexible drain hose into the drain pipe of main unit as far as it will go. Fix it with hose band.
REQUIREMENT
Mount the flexible drain hose using the hose band without using adhesive.
Hose band
Flexible
drain hose
19-EN
As long as possible
(Approx. 10 cm)
Arched shape
Downward slope
Trap
VP30
1/100 or more
Incorrect
15 mm or less
Flexible
drain hose
Indoor unit
Hose band
10 mm
Gravitational drainage
1
Reattach the drain cap.
* For gravitational drainage, remove the white connector
(CN504) on the upper left of the circuit board in the
electrical control box.
2
Insert fl exible drain hose into lower drain pipe and
fi x it with hose band.
3
Remove drain pump connector CN504.
Drain up
When a down-gradient cannot be secured for the drain pipe, drain-up
piping is possible.
The height of the drain pipe must be 850 mm or less from the underside
of the indoor unit.
Take the drain pipe out of the drain pipe joint with the indoor unit in
300 mm or less, and bend up the pipe vertically.
Immediately after the pipe is bent up vertically, lay the pipe making a
down-gradient.
– 10 –
Upper pipe
Lower pipe
Move the drain cap from
the lower pipe to the
upper pipe.
CN504
Red
Black
For drain pipes that will be
connected after setup, make a
downward slope of 1/100 or more.
300 or less
Flexible drain hose
(supplied)
Drain up setup dimensions
20-EN