Descargar Imprimir esta página

Helite Airbag OFF-ROAD Manual De Instrucciones página 39

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Change of mode
The LED turns blue + 1 beep
every 5 s. during 30 s.
Change of mode
Alternating cyan and green
flashing LED + series of beeps
Change of mode failed
The LED turns red + 4 beeps
Battery low
The LED flashes orange +
no beep
Battery very low
The LED flashes orange + 3
beeps when you switch the
airbag on/off
Battery is charging
The LED turns orange +
no beeps
Battery is charged
The LED turns green +
no beep
Airbag not working
The LED flashes red +
series of beeps.
CAUTION, a problem has
occurred.
8. SERVICING AND MAINTENANCE
a) Washing and care of the OFF-ROAD airbag
Please follow these instructions to avoid damage to the OFF-ROAD airbag. Do
not machine wash, do not wash by hand, do not immerse in water or dry clean.
The only way to clean the airbag is with a soft cloth slightly soaked in soap. Do not
use detergents or bleach. We recommend that you dry them on a hanger in a dry
place. Do not put it in the dryer, on a radiator or near a heat source. Do not iron.
The sleeves are removable, you can remove them from the OFF-ROAD airbag to
machine wash them at 30°.
Change of detection mode,
you have 30 s. to go to the
next step.
Change in progress of
detection mode :
adventure - rally/enduro.
Repeat the procedure to
change the detection mode.
Recharge the airbag,
2 h of battery remaining.
Recharge the airbag,
30 min of battery remaining.
Wait until the airbag is com-
pletely charged.
Unplug the charger, you can
use the airbag.
- Cartridge disconnected:
connect the cartridge.
- Empty cartridge, damaged
cable: replace with a new
cartridge.
- Other cases: please contact
the customer service.
39

Publicidad

loading

Este manual también es adecuado para:

Off-road v2