Helite Airbag OFF-ROAD Manual De Instrucciones página 42

42
English
11. CERTIFICATIONS
EN 17092-6:2020 : reference norm
Protective clothing for motorcyclists.
C : level of protection.
U : product worn under the equipment.
C U
EN 17092-6:2020
The product OFF-ROAD V2 has been certified CE according to experts by ALIENOR
CERTIFICATION notified body n° 2754 (Zone du Sanital, 21 Rue Albert Einstein
CHATELLERAULT-France) following the protocol AMC-012 : 02/2020 and norm NF EN
17092-6 :2020. The OFF-ROAD V2 airbag is certified for use on the road when worn
under an approved motorcycle jacket.
The logo certifies that the product complies with the requirements of EU
Regulation 2016/425. The EU declaration of conformity can be consulted on helite.
com.
The CDU electronic card with the remote HMI is certified IEC 62368-1 / EN-62368-1
/ UL62368-1 / CSA62368-1 by TÜV Rheinland (Tillystr. 2, 90431 Nürnberg, Germany)
notified body no. 0197.
Helite declares that the CDU electronic card complies with the essential
requirements and other relevant provisions of the RED (Radio Equipment Directive)
2014/53/EU and RoHS 2011/65/EU.
ISED Statement:
For general products, this device contains licence-exempt transmitter(s) that
comply with Innovation,
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) this device may not cause interference ;
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
FCC Statement:
For general product, this device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference;
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
Science and Economic Development Canada's