Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
6. INTRODUCTION
How to Use This Manual
To ensure safe operation, read the entire manual, including the chapter on safety instructions and warnings.
Receipt of Equipment
When you receive the equipment, check it against the invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If there is any damage, notify the carrier immediately to file a
claim. Furnish complete information concerning damage claims or shipping errors to the location in your area listed
in the inside back cover of this manual. Include all equipment identification numbers along with a full description of
the parts in error. Move the equipment to the installation site before un-crating the unit. Use care to avoid
damaging the equipment when suing bars, hammers, etc., to nu-crate the unit.
Description
The machine takes the guess work out of welding with an impressive SYNERGIC SET function that allows the user
to weld like a Pro with no previous welding experience necessary.
User Responsibility
This equipment will perform as per the information contained herein when installed, operated, maintained and
repaired in accordance with the instructions provided. This equipment must be checked periodically. Defective
equipment (including welding leads) should not be used. Parts that are broken, missing, plainly worn, distorted or
contaminated, should be replaced immediately. Should such repairs or replacements become necessary, it is
recommended that such repairs be carried out by appropriately qualified persons approved by Furius. Advice in this
regard can be obtained by contacting an Accredited Furius distributor.
This equipment or any of its parts should not be altered from standard specification without prior written approval
of Furius. The user of this equipment shall have the sole responsibility for any malfunction which results from
improper use of unauthorized modification from standard specification, faulty maintenance, damage or improper
repair by anyone other than appropriately qualified persons approved by Furius.
Packaged Items
- Inverter Power Source
- MIG Torch - 2M
- Feed rolls: 0.8/0.9mm "K" knurled or 0.030/0.035inches "K" knurled (only for FCAW)
0.6/0.8mm "V" Groove (only for GMAW)
- Work Clamp with 1m or 1.5m or 2m Lead
- Shoulder Strap
- Operating Manual
13
Publicidad
