Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
WARNING
When feeding the welding wire through the gun, the drive roll, the gun connector block and the gun contact
tip are always energized relative to work and ground.
WIRE STICKOUT
10. Remove the contact tip and nozzle from the gun.
11. Turn the machine ON ("1").
12. Straighten the gun cable assembly.
13. Depress the gun trigger switch and feed welding wire through the gun and cable. (Point the gun away
from yourself and others while feeding wire). Release the gun trigger after wire appears at the end of the
gun.
14. Turn off the machine.
15. Replace the nozzle and contact tip. Refer to Figure 4. Cut the wire off so the 3/8" to 5/8" (10-15mm)
protrudes from the end of the tip.
16. Turn on the machine. The machine is now ready to weld.
Contact tip
Wire electrode
3/8" to 5/8" contact tip
to work distance (CTWD)
21
Publicidad
