Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
3. Connect the gas
line to the
regulator and
connect to the as
cylinder
2. Connect weld
power lead to"+"
1. Connect earth
lead to "-"
6. Place wire onto spool holder (spool retaining
nut is top thread) Feed the wire through the inlet
guide tube on to the drive roller.
9. Remove the gas nozzle and
contact tip from the front end of
the MIG torch.
5. Fit the correct sized Knurled Driver roller for Gas
wire or Solid Hard wire Remark: V Groove Drive
Roller for Steel Wire U Groove Drive Roller for Soft
Wire
10. Fit the correct size contact tip over
the wire and fasten tightly into tip
holder.
26
(7/8) Place wire onto spool holder (spool retaining
nut is top thread) Feed the wire through the inlet
guide tube on to the drive roller.
12. Fit the gas nozzle to
the torch head.
Publicidad
