Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
7. Carefully feed the wire over the drive roller into the outlet guide tube, feed through about 150mm into.
8. Align the wire into the groove of the drive roller and close down the top roller making sure the wire is in
the groove of the bottom drive roller, lock the pressure arm into place.
9. Apply a light amount of pressure to the drive roller. Too much pressure will crush the cored wire.
10. Remove the gas nozzle and contact tip from the torch neck.
11. Switch the Power Source ON/OFF switch located on the rear of the Power Source to the ON position and
the green LED in the front panel is illuminated.
12. Press and hold the MIG Torch switch to feed the wire through to the torch neck.
13. Fit the correct sized contact tip and feed the wire through it, screw the contact tip into the tip holder of
the torch head and nip it up tightly.
14. Not install the gas nozzle to the torch head.
15. Select the correct sized wire diameter.
16. Select welding parameter required on 'synergic' knob, based on the material thickness of the work
piece.
(3/4) Connect earth
lead to +
(2) Connect it to the
negative socket
23
Gas less flux-cored
torch
Work clamp
Publicidad
