Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
- When inching with the gun trigger, electrode and drive mechanism are "hot" to work and ground
and could remain energized several seconds after the gun trigger is released.
- Do not operate with covers, panels or guards removed or open.
- Only qualified personnel should perform maintenance work.
ITEMS REQUIRING NO MAINTENANCE
- Drive Motor and Gearbox - Lifetime lubrication.
- Wire Reel Spindle - Do NOT lubricate shaft.
ROUTINE AND PERIODIC MAINTENANCE
- BEFORE EACH USE -Check over machine and accessories for any obvious condition that may prevent safe
performance or operation, repair or replace items as necessary to correct any abnormal condition.
AFTER 5 MINUTES OF WELDING OR WHEN SPATTER ACCUMULATES ON THE CONTACT TIP:
- CLEANING TIP AND NOZZLE- With the power switch in the OFF position, keep the contact tip and nozzle clean to
avoid are bridging between them. Bridging can result in a shorted nozzle, poor welds and an overheated gun. Hint:
Anti-stick spray or gel, available from a welding supplier, may reduce buildup and aid in spatter removal.
7.2 Daily maintenance
The power of the switching box and the welding machine should be shut down before daily checking (except
appearance checking without contacting the conductive body) to avoid personal injury accidents such as electric
shock and burns.
1-Daily checking is very important in keeping the high performance and safe operation of this welding machine.
2-Do daily checking according to the table below, and clean or replace components when necessary.
3-In order to ensure the high performance of the machine, please choose components provided or recommended by
Furius. when replacing components.
33
Publicidad
