Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
10. OPERATION
Read and understand this entire section before operating your machine.
Safety Precautions
Do not attempt to use this equipment until you have thoroughly read all operating and maintenance
manuals supplied with your equipment and any related welding machine it will be used with. They include
important safety precautions, operating and maintenance instructions and parts lists.
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts such as output terminals or internal wiring.
• Insulate yourself from the work and ground.
• Always wear dry insulating gloves.
WELDING SPARKS can cause fire or explosion
• Keep flammable material away.
• Do not weld upon containers which Held combustibles.
ARC RAYS can burn
• Wear eye, ear and body protection.
FUMES AND GASES can be dangerous.
Although the removal of the particulate matter from welding smoke may reduce the ventilation
requirement, concentrations of the clear exhausted fumes and gases may still be hazardous to health. Avoid
breathing concentrations of these fumes and gases. Use adequate ventilation when welding.
11. Installation Setup for MIG without gass
1. Switch the Power Source ON/OFF switch located on the rear of the power source to the OFF position.
2. Connect the weld power cable to the Negative socket and tighten it.
3. Connect the earth cable plug into the Positive socket and tighten it.
IMPORTANT: Loose welding terminal connections can cause overheating and result in the male
plug being fused in the terminal. Remove any packaging material prior to use. Do not block the air vents at
the front or rear of the Welding Power Source
4. Check the Weld Power Cable is connected to the Negative terminal.
5. Fit the correct size Knurled drive roller for Gas Less Flux Core wire.
6. Place the Wire Spool onto the Spool Holder-Note: the spool retaining nut is top thread. Snip the wire from
the spool being sure to hold the wire to prevent rapid uncoiling. Feed the wire into the wire feeder inlet
guide tube through to the drive roller.
22
Publicidad
