Stiga MPST 84 Li 48 V1/V2 Manual De Instrucciones página 300

6.8 TIPPING LEVER FOR GRASS
CATCHER (IF AVAILABLE,
ONLY FOR MODELS WITH
REAR GRASS CATCHER)
This lever, removable from its seat,
allows the grass catcher to be overturned
for emptying, reducing the effort
required by the operator (fig. 12.E).
6.9 PUSHBUTTON PANEL
Depending on the model, the
machine can be equipped with one
of the pushbutton panel versions
(fig. 12.C, fig. 12.D and fig. 12.L) described
below: :
6.9.1 Pushbutton panel (type "I") fig. 13
Machine start button
With the key fully inserted this
button (fig. 13.A) turns the machine
ON and enables all functions.
NOTE
If all safety conditions are met,
the "READY" icon comes ON
(fig. 13.K) and the machine is
ready to be used (see par. 7.4).
Cutting means engage and
disengage pushbutton
Press the button fig. 13.B to engage/
disengage the cutting means.
• When the cutting means
are engaged, they become
operational after a few seconds.
• When the cutting means are
disengaged, a brake is applied
simultaneously to stop them
rotating after a few seconds.
NOTE
If the cutting means are engaged
without taking the necessary
safety precautions, the machine
shuts down and cannot be
restarted (see par. 7.2.2)
Reverse gear cutting
enable button
Holding down the button
fig. 13.C gives consent
for reverse mowing.
For reverse cutting, engage the
cutting means and simultaneously
hold down the button.
NOTE
A single buzzer signal indicates the
lack of consent for reverse cutting.
Beacon ON button
Pushing the button fig. 13.D turns
the beacon on/off.
When the beacons are ON,
icon fig. 13.L is illuminated
Attention icon
If icon fig. 13.E is illuminated, it
this indicates failure to comply
with safety conditions or a
possible malfunction of the
machine (see chap. 15).
Battery LED
The LEDs fig. 13.F generally
indicate the charge level of the
machine's batteries but in particular
combinations their lighting status
provides information about machine
malfunctions (see chap. 15).
"Ready" icon
The icon in fig. 13.K is
illuminated when the machine
is ON and ready to be used.
"Bluetooth" icon
The icon in fig. 13.M is illuminated
when the machine and the data
exchange device are connected.
Controller and/or motor
over-temperature icon
The icon in fig. 13.N indicates
overheating of electrical
components. See chap. 15.
Transmission engagement /
disengagement lever icon
The icon in fig. 13.O is illuminated
when the transmission is not
engaged (see par. 6.3 and chap. 15).
Operator on-board icon
The icon in fig. 13.P is illuminated
when operator leaves the
driving seat (see par. 7.2.2).
EN - 14