Publicidad
Idiomas disponibles
Idiomas disponibles
CHOOSING A LOCATION
This spa is designed for indoor or outdoor use. Factors to consider when
choosing a location for the spa include: weight of the spa, indoor/out-
door location and drainage.
The following section provides guidelines that must be followed. It is the
sole responsibility of the spa owner to ensure proper installation of the
spa.
IMPORTANT:
The base upon which the spa is placed must be smooth, fl at, level
and capable of uniformly supporting the combined weight of the spa,
water and users, without shifting or settling, for the entire time the spa
is in place. If the spa is placed on a surface which does not meet these
requirements, damage to the Spa Skirt and/or Spa Shell may result. Da-
mage caused by improper support is not covered by the manufacturer's
warranty. It is the responsibility of the spa owner
to ensure the integrity of the supporting structure at all times. SPA BASE:
We recommend a poured, steel reinforced concrete slab with a minimum
thickness of 4 inches (10cm). Wood decking is acceptable if it is construc-
ted so that it meets the structural requirements outlined above.
The spa location must provide drainage away from the spa. Placing the
spa in a depression without provisions for proper drainage could allow
rain water, snow melt, overfl ow and other casual water to fl ood the equi-
pment bay, creating a wet condition in which the spa could be damaged.
For spas recessed into a deck, installation must permit access to the spa
access panels, either from above or below for servicing.
Ensure that there are no obstructions which would prevent removal of all
access panels and access to jet components, especially on the side of the
access panels (typically under the topside Console).
WEIGHT CALCULATIONS:
See spa specifi cations for exact weights. Typically the dry weight of a
spa can range from 600-1000 lbs (US) (220-455 kg) dry. The volume
of the spa can range from 300-400 gallons US (1135-1515 litres). Use
the average weight of water (8 lbs (US) per gallon or 2.1 kg per litre) to
approximate the total weight of the spa without users.
locating your spa
OUTDOOR LOCATION
Considerations for selecting an outdoor spa location:
• Proximity to the power source (long length of cable can be expensive)
• Local building and home owner association codes pertaining to the
installation of a portable spa
• Do not place your spa within 3m of overhead power lines. Make sure
the spa is positioned so that access to the equipment compartment and
all side panels will not be blocked. Be certain that your installation will
meet all relevant local, and national safety codes and requirements.
• How you intend to use your spa will help you determine where you
should position it. If your spa is mainly used for family recreation be
sure to leave plenty of room around it for activity. If you will use it for
relaxation and therapy, you'll probably want to create a specifi c mood
around it.
• If you live in a region where it is cold or rains frequently, place the spa
near a house entry.
• In a cold-weather climate, bare trees won't provide much privacy. Think
of your spa's surroundings during all seasons to determine your best
privacy options.
Consider the view of your neighbours when you plan the location of your
spa.
• Prevent dirt and contaminants from being tracked into your spa by
placing a foot mat at the spa's entrance where the bather's can clean
their feet before entering
your spa. You may also consider keeping a small water-fi lled basin
nearby for bathers to rinse their feet before enter your spa.
• Adequate space for spa with accessibility for service (Clearance of 3 ft
(1m) around the spa is recommended to permit servicing the unit)
• Proper structural support is critical. Consult a licensed professional
Structural Engineer to determine if the foundation will adequately support
the spa the entire time it will be in place, especially if the spa is to be
placed on a deck,
balcony, roof or other platform not specifi cally tied into the main structu-
ral support.
• Drainage: The area in which the spa is placed must have adequate
drainage to handle the entire water content of the spa. In the event of
spillage, areas around the spa may become wet; therefore, all fl ooring,
furniture, walls and adjacent structures should be able to withstand or
resist water and moisture.
• Pathway to and from the spa (free of debris, dirt and leaves as not to
be tracked into the spa)
• Closeness to trees and shrubbery (leaves and birds create extra clea-
ning)
• Sheltered environment (less wind and weather exposure results in lower
operating and maintenance costs)
• Proximity to changing area and shelter (especially in cold weather)
• Environmental factors such as rain, wind, snow and sunlight (run off
water, as from an unguttered roof overhang, shortens the life expectancy
of the spa cover)
• Accessibly to children (you should be able to monitor the use of the spa
from the home to prevent unauthorised use by children; you may want to
enclose the spa with a fence or a self latching gate to prevent unauthori-
sed use)
• Cover lift clearance (if you will be installing a cover lift as an addon
feature, allow 3ft (1m) on all sides of the spa)
5
Publicidad
