Publicidad
Idiomas disponibles
Idiomas disponibles
preferences
F / C (Temp Display)
Change the temperature between Fahrenheit and Celsius.
12 / 24 (Time Display)
Change the clock between 12 hr and 24 hr display.
RE-MIN-DERS (Reminders)
Turn the display of reminder messages (like "Clean Filter") On or Off.
Note: Reminders continue to run in the background even when not displayed. So turning the display of Reminders On or Off
does not reset any Reminder counts.
CLN-UP (Cleanup)
Cleanup Cycle Duration is not always enabled, so it may not appear. When it is available, set the length of time Pump 1 will
run after each use. 0-4 hours are available.
M8
(This message may not appear on all systems.) On systems that have M8, it is enabled by default. It can be disabled
(or re-enabled) here. M8 reduces polling intervals when the water temperature in the spa is steady.
DOL-PHIN-AD-DRES (Dolphin II and Dolphin III) Applies to RF Dolphin only.
(This message may not appear depending on the configuration)
When set to 0, no addressing is used. Use this setting for a Dolphin Remote which is factory set for no address by default.
When set between 1 and 7, the number is the address. (See the Dolphin manual for details.)
21
Publicidad
