Publicidad
Idiomas disponibles
Idiomas disponibles
POWER ON
When the electrical box is connected to the electric current, the boot sequence begins a series of numbers appearing on the display. If no button is
pressed, after the boot sequence LINK appears.
The Spa enter into Priming mode (mode priming). After priming, press the Jets
of pipes, particularly those associated with the heater. If the spa uses a recirculation pump, the button light
tion pump during the priming mode (mode priming). Priming mode (mode priming) automatically end after 4 minutes. Pressing the button tempera-
ture can manually exit Priming mode (mode priming).
When Priming mode (mode choke) just Pump 1 low speed or recirculation pump depending on the model will start. The temperature will not appear
on the screen until after a couple of minutes to circulate the water. Once the water temperature is registered, if less than the predetermined tempera-
ture the heater is activated.
BASIC OPERATIONS
The buttons
and
are often referred to as the temperature buttons. Some panels have only a single temperature button.
Once the predetermined temperature fl ashes on the screen, press the temperature button
spa are very distant). While the numbers are fl ashing, press the temperature button again to change the default temperature. Press and hold for
quick adjustment. The spa will heat the water to the new predetermined temperature.
The light button
on and off the lights in the spa and is used in combination with the temperature buttons to navigate the menu system.
PROGRAMMING
The deeper the navigation menu structure is done with only two or three buttons on the control panel.
Pressing light
as the set temperature is fl ashing it will be entered in the various menus.
Light
pressing again we move by the selection of menus. Pressing temperature
menu is displayed on the display will edit it directly or start a sequence editing.
Depending on what is shown on the screen, waiting between 10 and 30 seconds we will allow the spa returns to normal operation the spa establi-
shed.
FILTRATION
The system is factory programmed with a cycle fi ltering function at sunset (assuming temporary menu is set correctly) when electricity rates are often
lower. The onset and duration of fi ltering are programmable.
A second fi lter cycle can be activated if necessary.
DOUBLE TEMPERATURE RANGE
This system incorporates two temperature ranges, with independent temperature fi elds. The high range indicated
on the display with
where the temperature should be checked between 80˚F and 104˚F (26.7˚C to 40˚C).
The low range indicated on the display
The low range can be economical during periods of nonuse. More specifi c ranges can be determnados by the manufacturer.
READY AND REST MODE
If filtration is performed with a two-speed pump, at mode
water temperature, the heater you need is activated and the temperature display is refreshed the display.
The
mode heat only during filter cycles. The display will only show the temperature 2 minutes after the filter cycle is running.
when the spe is in REST and the button is pressed
12
spa operations - TP500S
by marking between 50˚F and 99F (10C to 37.2˚C).
will circulate water every half hour using the pump at low speed to maintain constant
.
Icons
A
B
C
D
E
F
G
to plug the pumps and verify that the air has been purged
will plug and turn off the recircula-
(often the default and the current temperature of the
while one
O
N
M
L
H
I
J
K
play
/
dis
Publicidad
