Publicidad
Idiomas disponibles
Idiomas disponibles
Core200
7.
PROGRAMMING
The machine is programmed by default. Should the
settings need to be modified, proceed as described in
the following paragraphs.
7.1
Coffee doses
• Always programme the right
push-button panel first. This way,
both push-button panels are au-
tomatically programmed. If neces-
sary, programme the left later;
• place the cup under the dispens-
ing spout;
• press the
button for at least
5 seconds until the
flashes;
• press the desired dose button, for
example
;
• to confirm the dose, press the
button again;
• repeat this operation for the other
dose buttons;
• when the programming is com-
plete, press the
wait 20 seconds.
The programming of every dose must be
carried out with ground coffee and not with
previously used coffee dregs.
The system automatically exits the
programming mode 20 seconds after the
last operation was carried out.
Do not remove the filter holder from the
dispensing group when coffee is being
dispensed.
Do not insert your fingers or any other objects into the filter holder.
42
button
button, or
7.2
Hot water (SAE Version)
• Place the pot under the hot water
spout;
• Press the
button for at least
5 seconds until the
flashes ;
• Press the
button;
• To confirm the dose, press the
button again;
• when the programming is com-
plete, press the
wait 20 seconds.
Avoid contact with the hot water nozzle,
do not place your hands or other body
parts near the hot water nozzle tips.
button
button, or
User manual
Publicidad
