Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
NOTE: The remote has been pre-paired in the
factory for your convenience.
NOTE: Batteries will weaken with age and should
be replaced before leaking takes place as this will
damage the remote control. Dispose of used
batteries properly and keep them out of the reach
of children.
1.
Remove the battery cover by pressing firmly on
the arrow and sliding the cover off.
2.
Install two 1.5V AAA batteries (included).
3.
Replace the battery cover on the remote
control.
LEARNING PROCESS
IMPORTANT: If you have two or more fans, please
follow steps below to control each fan independently.
Also follow steps below to re-pair the remote and
the receiver when needed.
NOTE: The dip switch in the battery compartment
has been set on "0" position for your convenience.
If you want to re-pair the remote, please set the dip
switch on "1" position.
To add a remote to your fan's memory, use the
steps below:
Ensure AC power to the fan is OFF to begin the
learning process.
Slide the dip switch in the battery compartment to
the "1" position.
Turn the fan's AC power ON.
NOTE: If installing multiple fans on separate remotes,
only the fan being programmed should have AC
power turned ON. All other fans, even if they have
already been programmed, should have AC power
OFF so they do not memorize other remotes during
the learning process. Separate the fan power
switches by approximately 2 meters.
Within 30 seconds of turning AC power on, press
and release the "LEARN" button located in the
remote's battery compartment to enter the learning
function. The down light of your fan, if applicable,
will blink, and the fan blades will start to spin.
1
Batteries
The fan will now accept commands from the added
remote.
If you would like to set the dip switch back to the
"0" position after a learning, please re-pair the
remote by following the learning process again.
1
LEARN
Remote
Control
12
LEARN
LEARN
Remote
Control
Publicidad
