Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING
WARNING: Check to see that all
connections are tight, including ground,
and that no bare wire is visible at the wire
nuts, except for the ground wire.
CAUTION: Do not use with a wall light
dimmer switch.
NOTE: The fan must be installed at a
maximum distance of 20 ft. from the
remote control for proper signal
transmission between the remote control
and the fan's receiving unit.
1. If you feel you do not have enough electrical
wiring knowledge or experience, have your
fan installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the plastic
wire nuts (AA & BB) with your fan. Secure
the plastic wire nuts with electrical tape.
Make sure there are no loose strands or
connections.
Make wire connections from the receiver
and fan to the outlet box as follows, using
the wire nuts (AA & BB).
From fan
Blue Wire --------------------- Blue Wire "For
Black Wire -------------------- Black Wire "To
White Wire ------------------- White Wire "To
From receiver
Black wire "AC in L" -------- Black wire (hot)
White wire "AC in N" ------- White wire
From mounting plate
Green wire ------------------- Green or bare
Turn the wire nut connections upward,
spreading them apart so the green
(ground) and white wires will be on one
side and the black and blue wires will be
on the other side.
To receiver
Light"
Motor L"
Motor N"
To outlet box
(neutral)
To outlet box
wire (ground)
9
1
Black
Receiver
Ground
White
conductor
Outlet Box
Publicidad
