Toyotomi FF-V30T Instrucciones De Uso página 13

SECTION D:
OPERATION
1. Filling Fuel
FF-V30T:
• Do not fill the removable tank in the living room, but in a more
suitable place(there can always be some spillage).
• Do not refuel the heater while in operation or still hot.
Follow the procedure below:
1) Make sure that the heater is switched off.
2) Open the tank lid and lift the removable tank out of the heater.
NOTE: Some drops may leak from the tank. Put down the removable
tank (cap pointing upwards) and screw off the fuel cap.
3) Take the manual fuel pump and insert the smooth, most rigid tube
into the can.
Make sure that it is in a higher position than the removable tank.
Insert the ribbed hose into the opening of the removable tank.
4) Lock the switch button on top of the pump (turn clockwise).
5) Squeeze the pump a few times, until fuel starts flowing into the
removable tank.
As soon as this happens, there is no need to press any longer.
6) Check the removable tank fuel gauge while filling the tank. Stop
filling by loosening the switch button on top of the pump (turn anti-
clockwise), once the gauge indicates that the tank is full. Never
overfill the tank, especially not when the fuel is very cold (fuel
expands when it heats up).
7) Let the remaining fuel in the pump flow back into the can and
carefully remove the pump. Carefully screw the fuel cap back on
the tank. Clean off any spilled fuel.
8) Check whether the fuel cap is straight an tightened properly. Reinstall the removable tank in the heater (cap
down). Close the tank lid.
FF-V30:
1) Open the Valve(s)
Open the valve(s) of the external fuel tank.
2) Start the Fuel flow
If using heater for the first time, press the red float release button in order to
send fuel to the fuel sump and release.
NOTE: Make sure there is no fuel leakage from the fuel line or joints.
Also make sure fuel tank is not too high. See installation instructions.
NOTE: Red Float Release Button is for first time installation, or on rare
occurrences when the fuel tank is filled. This red button is to release
the fuel sump float. It does not prime the fuel into the sump. Pushing
the Red Float release Button, too many times or for too long of a
period WILL cause flooding of the fuel sump, which can result in a
possible fire. Only every push the Red Float release Button once, with
a quick press of less than one second.
2. Plug in the Heater
Plug in heater into 220V or 230V AC electrical outlet. (See SECTION A:
SPECIFICATIONS.) On Display pre-set "Two Dashes" will be showing.
NOTE: Do not connect to an outlet shared with other appliances.
FF-V30T_FF-V30_Type E_6 language_A4.indb
BEFORE IGNITION
7
ENGLISH
empty full
Red float
release button
GB
7
2023/06/21 17:59:14