Toyotomi FF-V30T Instrucciones De Uso página 15

MANUAL OPERATION
Operation of the heater is under the direct control of the user. Heat output will, however, be automatically adjusted
in accordance with the room temperature registered by the temperature sensor.
1. Turning Heater ON
A. Press ON/OFF button to "ON" position. The current room temperature and the set
temperature will be shown on the Display. If the room temperature is below the set
temperature then. ON lamp will start to flash and then blower motor and ignition will
start. This lamp will continue to flash during the preheating time.
B. Pre -heating depends on the room temperature. After approx. 1.5 – 4 minutes
ignition will take place. (*) After ignition, ON lamp will change flashing to continuous.
Circulation fan will turn on after approx. 2 minutes.
NOTE: (*) Pre -heating depends on the room temperature.
Room temperature:
below 0˚C
0˚C - 15˚C
15˚C Over
2. Adjusting Room Temperature
A. Press "sMIN." or "tHOUR" button. ˚F or ˚C will start to flash.
NOTE: "sMIN." or "tHOUR" button will change the temperature in increment of 1°C
(2°F).
B. Press "sMIN." for up and "tHOUR" for down. Room temperature can be set from
10˚C (50˚F) to 32C (90˚F). (Initial setting : 13˚C (56˚F))
C. When room temperature reaches the selected setting, heater will automatically shift
to "MED" or "LOW" burning mode to maintain the desired temperature.
When room temperature exceeds the selected setting by approx. 2˚C (4˚F), the
heater will automatically shut off. As room temperature drops, the heater will
automatically re-start to maintain the desired temperature.
POWER SAVER OPERATION
The Power Saver mode reduces the frequency of ignition actions, to save electric
consumption.
1. Press the POWER SAVER (CHILD LOCK) button "ON" while in operation to start the
operation of the "POWER SAVER". "POWER SAVER" sign will be shown on the display.
When the room temperature exceeds the selected setting by approximately 6˚C (12˚F),
the heater will automatically shut off. As the room temperature becomes lower than
the selected setting, the heater will automatically re-start to maintain the desired
temperature.
FF-V30T_FF-V30_Type E_6 language_A4.indb
OPERATION
Approx. 4 minutes
Approx. 2 minutes
Approx. 1.5 minutes
9
ENGLISH
GB
9
2023/06/21 17:59:15