Cockpit App; System Requirements; Initial Connection Between Cockpit App And Prosthesis; Starting The Cockpit App For The First Time - Ottobock 1B1-2-Meridium Instrucciones De Uso

7 Cockpit app

INFORMATION
The Cockpit app can be downloaded free of charge from the respective online store. For more
information, please visit the website: http://www.ottobock.com/cockpitapp. To download the
Cockpit app, the QR code on the supplied Bluetooth PIN card can be read with the mobile
device (requirement: QR code reader and camera).

7.1 System Requirements

The functioning of the cockpit app is assured on devices with the Android operating system ver­
sion 4.0.3 or higher.
The functionality was tested on the following devices:
• Samsung Galaxy S7, Galaxy S5, Galaxy S4 mini, Galaxy SIII mini, Galaxy Note II, Galaxy
Fame
• Sony Xperia Z, Xperia Z3, Xperia J
• HTC One, One mini
• LG Optimus L9, Optimus F5, Optimus G2, G4
• Huawei Ascend P6, Ascend G500, P9 Lite
• Motorola Droid Razr Maxx, Moto X, Moto G, Moto G3
• Google Nexus 4, Nexus 5, Nexus 6

7.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of
the foot must point up) or by connecting/disconnecting the battery charger. Bluetooth is then
turned on for approx. 2 minutes. During this time, the app must be started and used to estab­
lish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 71).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are
turned off.
The device must be connected to the internet.
•
• The serial number and PIN code of the component being connected must be known. They are
found on the enclosed Bluetooth PIN card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the PIN card and serial number of the component is lost, contact
your prosthetist.

7.2.1 Starting the cockpit app for the first time

1) Tap the symbol of the Cockpit app (
58
The cockpit app enables switching from basic mode into the pre-configured
MyModes. In addition, information about the product (step counter, battery
charge level, etc.) can be called up.
The behaviour of the product can be changed to a certain extent on a day-to-
day basis using the app (e.g. while becoming accustomed to the product). At
the next appointment, the prosthetist can trace the changes using the adjust­
ment software.
).