Scope Of Delivery And Accessories; Charging The Battery - Ottobock 1B1-2-Meridium Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 165
NOTICE
Failure to observe the system requirements for the installation of the cockpit app
Malfunction of the device.
Install the cockpit app only on the operating systems listed in the section "System require­
ments" (see Page 58). The tested devices are listed in this section as well.

5 Scope of Delivery and Accessories

Scope of Delivery
1 pc. 1B1-2 Meridium
1 pc. 757L16* power supply
1 pc. 4E50 Battery Charger for C-Leg
1 pc. 646C107 Bluetooth PIN card
1 pc. 647G1332 instructions for use (user)
1 pc. 647G1332=1 instructions for use (user)
Android
app
http://www.ottobock.com/cockpitapp
Accessories
The following components are not included in the scope of delivery and may be ordered separ­
ately:
1 pc. 4X350 remote control
The user interface is available in the following languages: German, English, French, Italian,
Spanish, Dutch, Swedish
1 pc. 757P48 Y adapter cable
This is for charging more than one product at the same time (e.g. 1B1-2; 1B1; 3B1/3B1=ST;
3B1-2/3B1-2=ST; 3B5-X3/3B5-X3=ST; 3C98-2/3C88-2; 3C98-3/3C88-3; 3C96-1/3C86-1)
with the 757L16* power supply.

6 Charging the battery

The following points must be observed when charging the battery:
The capacity of a fully charged battery is sufficient for one full day.
We recommend charging the product every day when used on a daily basis.
When used daily, the complete charging unit (power supply – battery charger) may remain
plugged into the wall socket.
For the maximum operating time with one battery charge, disconnecting the battery charger
from the product only immediately before using the product is recommended.
The battery should be charged until the yellow LED on the battery charger turns off prior to
initial use, and for at least 4 hours. This calibrates the charge level indicator via the Cockpit
app/remote control and by turning over the prosthesis.
If the battery charger is disconnected from the prosthesis too soon, the charge level indicator
via the Cockpit app/remote control and by turning over the prosthesis may not correspond to
the actual charge level.
Use the 757L16* power supply and 4E50* battery charger to charge the battery.
The ankle joint of the prosthetic foot is locked during the charging process.
The battery may discharge while the product is not being used.
"Cockpit
4X441-Andr=V*"
for
download
from
the
website:
55

Publicidad

Tabla de contenido
loading

Tabla de contenido