Information On The Use Of A Mobile Device With The Cockpit App - Ottobock 1B1-2-Meridium Instrucciones De Uso

CAUTION
Safety mode cannot be deactivated
Falling due to unexpected product behaviour because of changed damping behaviour.
► If you cannot deactivate safety mode by recharging the battery, a permanent malfunction has
occurred.
► Do not continue using the defective product.
► The product must be inspected by an authorised Ottobock Service Centre. The prosthetist
is your contact person.
CAUTION
Safety signal occurs (ongoing vibration)
Falling due to unexpected behaviour of the product because of changed damping behaviour.
► Observe the warnings/error signals (see Page 77).
► Do not continue using the product after the safety signal has been emitted.
► The product must be inspected by an authorised Ottobock Service Centre. In this case, the
contact person is your prosthetist.

4.9 Information on the use of a mobile device with the cockpit app

CAUTION
Improper use of the device
Falling due to altered damping behaviour as a result of unexpected switching into MyMode.
► Make sure you have been instructed in the proper use of the device with the cockpit app.
CAUTION
Independently applied changes or modifications made to the device
Falling due to altered damping behaviour as a result of unexpected switching into MyMode.
Do not make any independent changes to the hardware of the device.
►
► Do not make any independent changes to the software/firmware of the device which are not
included in the update function of the software/firmware.
CAUTION
Improper mode switching with the device
Falling due to unexpected product behaviour because of changed damping behaviour.
► Ensure that you stand securely during all switching processes.
► Verify the changed damping characteristics after switching and observe the feedback from
the acoustic signal emitter (beeper) and the display on the device.
Switch back to basic mode once the activities in MyMode have been completed.
►
NOTICE
Destruction of the device due to falling or penetration of water
Malfunction of the device.
► If necessary, let the device dry at room temperature (at least 1 day).
► If it should no longer be possible to switch back from a MyMode to basic mode, the com­
ponent can only be switched back to basic mode by using a movement pattern (see
Page 68) or by connecting/disconnecting the battery charger.
54