Zipro Force Gold Manual De Uso página 17

EN
ADJUSTMENTS
Step length
BUTTONS
• ENTER - in STOP mode is used to confirm your selection; in START mode it allows you to change the SPEED or RPM display or switch automatically.
• START/STOP - is used to start or stop a workout.
• UP - in STOP mode when the dot matrix blinks, is used to change the programme. When the value in the window blinks, it is used to increase the active
value. In START mode it allows you to increase the resistance level (LEVEL).
• DOWN - in STOP mode when the dot matrix blinks, it is used to change the programme. When the value in the window blinks, it is used to decrease the
active value. In START mode, it allows you to decrease the resistance level (LEVEL).
• RECOVERY- allows you to check your fitness and training level based on the rate at which your heart rate drops after training. In PULSE RECOVERY mode,
press to exit the programme.
FUNCTIONS (SPECIFICATION)
TIME
SPEED
LEVEL
DISTANCE
ODO
CALORIES
RPM
PULSE
WATT
MANUAL
PROGRAM P1-P10
USE P11-P15
WATT PRO P16
PULSE PRO P17-P20
BODY FAT P21
17
Step length is adjusted by setting the angle of the guide rails. 3 settings are possible: 5°, 10°, 15°. The lever for changing
the setting is located on the back of the housing. To change the setting, press and hold the handle while simultaneously
raising or lowering it to the desired position. Release the handle after setting and lock the rails. Correctly locked height
is indicated by a click.
CAUTION! Be careful when changing the setting. Do not touch the rails or other components when raising or lowering.
Do not allow children to operate the levers. Improper operation may cause an accident.
Total exercise duration, from the start to the end.
Set target time.
Displays the current speed.
Displays the current resistance level.
Total distance from the start to the end of the exercise.
The travelled distance.
Counts the total distance travelled.
Total calories burnt from the start to the end of the exercise.
(The measurement is an approximation for comparing training sessions. Do not use for medical
purposes).
Displays cadence (revolutions per minute).
Visualisation – the column on the left-hand side of the screen.
Displays the current heart rate.
Energy used during training.
Manual programme.
Selects one of 10 programmes.
User selection U1-U5.
WATT controlled programme.
HRC heart rate controlled programme.
Body fat measurement.
COMPUTER MANUAL
Remove the safety film from the display before use.
COMPUTER (MODEL)
EBIC04PRO
TURNING ON
The computer turns on after power is connected.
It will display all elements on the screen within two seconds.
AUTO ON/OFF
The computer is switched on when the flywheel moves or any button is pressed.
The computer is switched off after four minutes of inactivity.
COMPUTER RESET
Press and hold the START/STOP button for 2 seconds to reset the computer.
Press and hold the ENTER and START/STOP buttons simultaneously for 2 seconds to
completely reset the computer and stored values and programs.
00:00-99:59 min
0,0-99,9 km/h
1-32
0,00-99,90 km
0,0-999,9 km
0,0-999 kcal
0–999 RPM
60-240 BPM
0-999