KYT NZ-Race Instrucciones De Uso página 17

EN
Inner side padding: CHEEK PADS
Assembly and disassembly
L L
Removing the pads — Figure 10
Grab the cheek pad (L) from the front part, push it to the back part of the helmet and then rotate
inwards until all the press studs are unhooked.
Assembly — Figure 11
Turn upside down the cheek pads from the original position.
Insert the fixing hook (M) in the red hooking hole (N). Put the back part of the cheek pad on the
fixed part of the inner lining. Verify that the fastening strap (O) is correctly inserted in the appropri-
ate seat (P). Push the cheek pad to the back part of the helmet and hook the press studs.
Verify that the part was assembled correctly by checking that:
- the cheek pad is firmly locked in position
- the strap is completely free inside the hole and is not blocked under the cheek
32
L
— — Figure 9
L L
FIGURE 9
L
FIGURE 10
pad during assembly.
Only the correct assembly of the cheek pad and the correct positioning of the strap
will assure the proper efficacy of the retention system. During use, the locking
lever must always be fixed in lock position; if it cannot be locked correctly do not
use the helmet.
VISOR — Q — R — S
The visor must be periodically cleaned and controlled. If the visor is dirty and/or has bad scratches
on the surface there could be unusual light reflections or deviations, which may jeopardize safety.
Immediately replace the visor if there are these problems.
How to operate — Figure 12
The Visor (Q) has to be operated only by using the lifting lever (R). Do not open it using other
areas to avoid causing accidental damages (scratches) or dirtying the field of vision.
Opening the visor: push lightly the lifting lever outwards (R), to unlock the tab from its seat (S)
under the gasket and lift it up.
Q
Q
R
EN
M
O
N
P
FIGURE 11
R
S
FIGURE 12
33