KYT NZ-Race Instrucciones De Uso página 18

Closing the visor: to lock the visor in position, lower it until the tab is blocked inside its seat (S) in
the gasket.
There are two locking positions: intermediate and visor completely open.
EN
The visor must be opened or closed completely up to the lock position. The visor is correctly
locked into position when it clicks into its seat. To unlock the visor from the lock position just
follow the above procedure, lightly press during initial phase of the movement until the visor is
unlocked.
While riding the motorcycle the visor must never be left in the intermediate posi-
tions; it must always be locked in the locking positions.
Removing the visor — Figure 13A
1) Open the visor until it is completely open.
2) Slide the lever (T) and Keep it in tension (T)
3) Remove the visor from its mechanism by rotating and at the same time pull it outwards. Repeat
the operation on the opposite side.
Assembly — Figure 13-B
To assure the proper operation of the rotation system of the visor, before fitting
the visor back on, verify that all the parts (seats on helmet, visor surface in contact
with the moving parts) are perfectly clean.
1
1
34
A
T
2
3
T
B
T
2
FIGURE 13 A-B
Open the visor completely. Position the visor on the mechanism so that the rotation seat is
inserted in the rotation ring.
1) Slide the lever (T)
2) Press slightly to stick the hooks on the visor into the slots on the rotation mechanisms
Repeat the operation on the opposite side.
After fitting the mechanism verify that the visor is tightly fixed to the helmet, that it rotates freely
and that it locks correctly into the locking positions.
If this doesn't happen and the rotation mechanism of the visor doesn't work cor-
rectly, do not use the helmet and contact authorized personnel only.
Adjustment — Figure 14
After replacing the part, or after long use of the helmet you experience infiltration from the closed
visor, it may be necessary to adjust the mechanisms of the visor.
Lift the visor until it is completely open.
Remove the visor, as specified in the previous paragraph.
Loosen the screws (U - V - W) without removing them and without disassembling the mechanism.
Shift horizontally the whole mechanism and tighten the screws.
Repeat the operations on the opposite side by shifting the mechanism on the same direction of the
previous one.
Once finished, check if the visor can be easily closed and if it adheres to the gasket
VISOR MECHANISM
Removing the mechanism
After removing the visor as indicated in the paragraphs above, loosen and remove the screws
U
W
(U - V - W); then remove the mechanism from the shell.
Fitting the mechanism
The mechanisms are not interchangeable. Before proceeding it is necessary to
identify the correct assembly side. Put the mechanism on the shell, insert the screws
tightening them.
After fitting the parts, verify that the mechanisms are positioned correctly and
tightly fixed to the shell. Then fit the visor and adjust it as specified in the above
paragraphs.
After fitting the mechanism verify that the visor is tightly fixed to the helmet, that it rotates freely
and that it locks correctly into the locking positions.
If this doesn't happen and the rotation mechanism of the visor doesn't work
correctly, do not use the helmet and contact authorized personnel only.
EN
V
FIGURE 14
35