TO ATTACH/DETACH BATTERY PACK OR
POWER ADAPTER (FIG. 3a - 3d)
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves in the battery bay, and then slide the
battery pack into the battery bay.
When placing the battery pack onto
NOTICE
the tool, be sure that the raised rib
on the battery pack aligns with the groove inside
the tool and that the latches snap into place
properly. Improper attachment of the battery pack
can cause damage to internal components.
To detach the battery pack:
Depress battery-release button located on the
front of the battery pack to release the battery
pack. Pull the battery pack out and remove it
from the tool.
WARNING
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious injury.
To operate with FLEX 24V power adapter
WARNING
FLEX 24V power adapter before using it. It
contains information not included in this
manual.
WARNING
repaired immediately.
WARNING
the nameplate. If operated at voltage higher
than indicated on the nameplate, the power
cable will burn up.
The table saw can be powered by a 24V battery
pack or a power adapter FLEX FX0511-Z (not
included) show in figure 3b.
a. Remove the battery pack from the table saw.
b. Attach the battery adapter to the battery bay
firmly and then connect the plug of the power
adapter to a regular power outlet (Fig. 2c).
c. To remove the battery adapter, depress the
release button, pull the battery adapter out
and remove it from the tool.
Do not attempt to modify
this tool or create
Read the operator's
manual included with
Do not use the electrical
cord if damaged. Have it
Do not use at voltage
higher than indicated on
ASSEMBLY
Fig. 3a
Detach
Fig. 3b
Cord
Power
Supply
Fig. 3c
-17-
Battery-release
Button
Release
Button
Battery Adapter
Attach
Indicator
Battery Adapter
Indicator
Release
Button