Descargar Imprimir esta página

Flex FX7211 Manual Del Operador página 21

Publicidad

Idiomas disponibles

Idiomas disponibles

TO INSTALL AND REMOVE THE ANTI-
KICKBACK DEVICE (FIG. 6)
WARNING
smart guard system when performing
"through cutting" operations. Replace dull or
damaged anti-kickback device. Dull or damaged
device may not stop a kickback increasing the
risk of serious personal injury.
a. Turn off the saw and disconnect the battery
pack.
b. Press the release button and position the anti-
kickback device on the top edge of the smart
guard system, below the notch.
c. Press the anti-kickback device down until it
drops into the notch.
d. Let go of the release button. Gently tug on the
anti-kickback device to ensure it is locked in
place.
TO CHANGE THE BLADE (FIG. 7a – 7d)
WARNING
performing any assembly or adjustments, or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
WARNING
thin kerf saw blades. The kerf of the blade
must be wider than 0.075'' (1.9mm). Extra thin
kerf saw blades less than 0.075'' (1.9mm) may
cause the work piece to bind against the riving
knife / splitter during cutting. It is recommended
that the kerf of the replacement blade used on
this saw be 0.075'' (1.9mm) or more (Fig. 7a).
WARNING
"dampeners," "stabilizers," or "stiffening
collars" on both sides of a replacement
blade. These are metal plates positioned
against the sides of the blade to reduce
deflection that may occur when using thin saw
blades. Use of these devices on both sides will
prevent the blade from being properly aligned
with the riving knife, which may bind the work
piece during cutting. One "stabilizer" plate may
be placed only against the outside of a thin
replacement blade. These plates are not
required with the supplied blade.
Always install the anti-
kickback device onto the
Disconnect the battery
pack from the tool before
To reduce the risk of
injury, do not use extra
To reduce the risk of
injury, do not use blade
Fig. 6
Notch
Fig. 7a
0.071"
MUST BE 0.075"
OR MORE
MUST BE LESS
THAN 0.067"
Fig. 7b
Arbor Lock Lever
-21-
Release Button
Anti-kickback Device
RIVING KNIFE
KERF WIDTH
BLADE TEETH
BLADE BODY
PLATE

Publicidad

loading