SHARPEN THE TEETH OF THE ANTI-
KICKBACK DEVICE (FIG. 41)
Make sure the teeth of the pawls of the anti-
kickback device are always sharp. To sharpen:
Remove the anti-kickback device.
•
Rotate one pawl away from the other.
•
Hold the pawl over corner of a workbench.
•
Use a small, round file (smooth cut) to sharpen
•
the teeth.
RAIL LOCK ADJUSTMENT (FIG. 42)
a. Loosen the rail locking lever.
b. On the underside of the saw, loosen the jam
nuts.
c. Tighten the hex rod until the spring on the
locking system is compressed, (not fully
compressed) creating the desired tension on
the rail locking lever. Retighten the jam nuts
against the hex rod.
d. Check that the fence does not move when the
locking lever is engaged. If the fence is still
loose, tighten the spring further.
CLEANING
The tool may be cleaned most effectively with
compressed dry air.
WARNING
tools with compressed air. Ventilation
openings and switch levers must be kept clean
and free of foreign matter. Do not attempt to
clean by inserting pointed objects through
openings.
WARNING
Model
FT722
FT724
FT721
Always wear safety
goggles when cleaning
RECOMMENDED ACCESSORIES
Use only recommended accessories. Follow instructions that accompany
accessories. Use of improper accessories may cause hazards.
Fig. 41
Fig. 42
WARNING
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
Store the tool indoors in a place that is
inaccessible to children. Keep away from
corrosive agents.
Product Description
Zero Clearance Insert
Dado Insert
Stand
-52-
Jam Nut
Hex Rod
Certain cleaning agents
and solvents damage
STORAGE