Publicidad
Idiomas disponibles
Idiomas disponibles
Set the rip fence pointer (Fig. 12d)
a. Lift both halves of the barrier guard to their up
locked position.
b. Place the fence over the index bolts 1 and
lock the rip fence lock levers on the front and
back.
c. Raise the rail locking lever and move the
fence until it is alongside the saw blade by
lifting the right pawl of the anti-kickback device
above the fence. Lock the rails in place.
d. Loosen the pointer adjustment screws.
e. Adjust the pointer to "0" mark on lower scale,
then re-tighten the screws.
RIP FENCE LED STRIP LIGHT
(FIG. 13a – 13c)
The rip fence features a built-in LED strip light to
illuminate the work surface.
To turn on the strip light, press the ON (I) half of
the light switch.
To turn off the strip light, press the OFF (O) half
of the light switch.
The strip light is powered by a battery integrated
into the rip fence. The battery will need to be
recharged periodically via the USB-C port.
a. Remove the rip fence from the saw.
b. Connect a USB-C cable to a USB power
adapter (both are not included). Connect
the USB power adapter to a standard power
outlet.
c. During charging, the indicator light will shine
red and will turn green when the charging
d. Disconnect the USB-C cable from the USB-C
port and disconnect the USB power adapter
from the power outlet once the battery is fully
charged.
WARNING
Supply, or Listed Class 2 Power Unit, using
USB-C port.
Only charge using any
Listed/Certified ITE Power
Fig. 12d
Rip Fence Pointer
Fig. 13a
Fig. 13b
Light Switch
Fig. 13c
-33-
Scale
Pointer Adjustment Screws
Rip Fence LED Strip
Light
Indicator
Light
USB-C port
Publicidad
