Flex FX7211 Manual Del Operador página 24

Miter gauge storage (Fig. 9a)
When not in use, store the miter gauge under
the back side of the table.
Insert the front end of the miter gauge into the
miter gauge storage slot located on the saw's
rear foot.
To remove the miter gauge, just pull it out.
Push stick storage (Fig. 9b)
When not in use, insert the push stick into the
push stick holder.
Rip fence storage (Fig. 9c – 9d)
When not in use, store the rip fence under the
right end of the table on the rails. Remove the
fence from its in-use position on the rails.
a. Ensure that the flip-over fence, in its stored
position (Fig. 9c).
b. Unlock the rails and extend the rails
approximately 2" (50 mm) to the right of the
table by rotating the rail adjustment knob
clockwise.
STORAGE AND TRANSPORTATION
Fig. 9a
Fig. 9b
Fig. 9c
-24-
Miter Gauge
Push Stick
Flip-over
Fence