Descargar Imprimir esta página

Flex FX7211 Manual Del Operador página 32

Publicidad

Idiomas disponibles

Idiomas disponibles

e. Tighten the front index bolt 1. Verify that the
fence is still in contact with the front and back
teeth of the blade.
f. Tighten the back index bolt 1. Verify that the
fence is still in contact with the front and back
teeth of the blade.
g. Secure the rip fence lock levers and ensure
that the fence is still in contact with the front
and back teeth of the blade.
Adjust the right side, position 2 (further from
blade). See Fig. 12c
The right side position 2 for the
NOTICE
fence permits cuts of 4 to 25
inches on the right side of the blade. The bottom
scale shows this dimension. In this location, the
flip-over fence should be on the left of the main
fence when in the material support position
(closest to the blade).
a. Release the rip fence lock levers and remove
the fence.
b. Use the included 5 mm Allen key to loosen the
right index bolts 2 on the front and back rails,
approximately 1/2 to 1 turn so that the bolts
can slide freely.
c. Place the fence alignment holes in the blade
wrench over the right index bolt 1 on the front
rail (already fixed in place as described in
chapter "Adjust the right side, position 1
(close to blade)" above) with the second hole
roughly aligned with the right index bolt 2.
d. Move the right index bolt 2 until the blade
wrench slides over the bolt head.
e. Tighten the right index bolt 2.
f. Perform steps "c" through "e" to adjust the
right index bolt 2 on the back rail.
Adjust the left side position. See fig. 12b
The left side position for the fence
NOTICE
permits cutting of 0 to 12 inches
on the left side of the blade. The scale does not
show this dimension. In this location, the flip-
over fence should be on the right of the main
fence when in the material support or auxiliary
fence position (closest to the blade).
a. Use the included 5 mm Allen key to loosen
the left index bolts on the front and back
rails, approximately 1/2 to 1 turn so that the
bolts slide freely. Move the bolts so they are
approximately 3.5 inches (89 mm) from the
left end of the rails.
Fig. 12c
Right Index
Bolt 1
b. Place the fence over the left index bolts but
do not secure the rip fence lock levers on the
front or back rail.
c. Move rails so that the fence touches at least
one tooth on the blade. Lock the rails in place
using the rail locking lever. If anti-kickback
device is installed, you will need to raise the
left side in order to align the fence with the
blade.
d. Slide the fence along with the front and back
index bolts towards the blade until the fence
touches the blade teeth at the front and back
of the blade.
e. Tighten the front left index bolt. Verify that the
fence is still in contact with the front and back
teeth of the blade.
f. Tighten the back left index bolt. Verify that the
fence is still in contact with the front and back
teeth of the blade.
g. Secure the rip fence lock levers and ensure
that the fence is still in contact with the front
and back teeth of the blade.
-32-
Right Index
Bolt 2
Blade Wrench

Publicidad

loading