Descargar Imprimir esta página

Flex FX7211 Manual Del Operador página 48

Publicidad

Idiomas disponibles

Idiomas disponibles

DADO CUTTING
Instructions for operating the saw with dado
head sets are contained in the booklet furnished
with these accessories.
Always use an appropriate table insert and
INSTALLING A DADO SET
A dado set is an accessory system used to
make non-through grooves or lap cuts in
workpieces.
These tools are commonly used in furniture and
cabinet building. After work pieces have been
properly dado cut, they can be tightly joined
together. This table saw can accommodate dado
cutting up to 1/2'' wide in a single pass.
WARNING
battery pack from the table saw before
changing blades.
USING STACKED DADO SETS
(FIG. 39a – 39c)
NOTE: These instructions apply to most
standard stacked dado sets.
a. Disconnect the battery pack.
b. Remove the smart guard system.
c. Remove the standard table insert plate. Raise
the saw blade to the maximum height.
d. Remove the arbor nut, then the outer washer,
and saw blade.
NOTE: For only dado cutting, leave the inner
blade washer in place. The outer washer will
be replaced with the combination nut/washer
included with the dado insert.
e. Installing a dado stack (Fig. 39a, 39b):
Place the desired parts of the dado set onto
the arbor shaft.
Place the supplied combination nut/washer
from the Dado Accessory Kit onto the outside
of the dado stack and tighten.
f. Placing dado blades and chippers (Fig. 39a):
For 1/4" wide cuts, place the two outer
dado blades (cutters) on the shaft. The
two dado outer blades may be different,
check for information on the blade and
the manufacturer's instructions for proper
installation.
To reduce the risk of
injury, always disconnect
washers listed in chapter "Recommended
Accessories."
Always place the blade washers in the original
positions when you are finished dado cutting.
Never make dado cuts without dado table insert.
Do not use dado sets larger than 6" in diameter.
Never set dado cutters to any bevel angle other
than the vertical 0° angle. Follow all warnings
and instructions shown here and those that
accompany your dado set. Failure to comply
with these warnings may result in serious bodily
injuries.
Fig. 39a
Inner Blade
Washer
Arbor
Outer Blade
Fig. 39b
-48-
Combination
Nut/Washer
Chippers
Outer Blade
Inner Washer
Use Accessory
Combination Nut/
Washer

Publicidad

loading