Flex FX7211 Manual Del Operador página 26

Allen key storage (Fig. 9g)
When not in use, store the Allen key under the
table.
a. Insert the long end of the Allen key into the
plastic loop.
b. Snap the short end into the Allen key storage
port.
WARNING
storage port. Allen key contacting the spinning
blade may create a hazardous situation.
Blade wrench storage (Fig. 9g)
When not in use, store the blade wrench on the
blade wrench bracket under the table.
Line up the mounting hole on the blade wrench
with the threaded rod on the blade wrench
bracket, and slide the blade wrench onto the
threaded rod until the blade wrench nests in the
blade wrench bracket.
To secure the blade wrench in place, install the
wingnut provided onto the threaded rod, and
tighten.
Foldable table extension (Fig. 9h)
To UNFOLD the table extension, just lift the
table extension. When the table is unfolded,
ensure that the lock levers of both brackets are
in locked (down) position.
To FOLD the table extension, press both lock
levers up and lower the table. The lock levers
of both brackets should be stuck on the table
locks.
Transporting the table saw
WARNING
battery pack before transporting the saw.
Table saw storage
Store tool only in orientation (A) or (B) as shown
in figure 9i. Storing tool in other orientation may
lead to tool damage.
Never insert the long end
of the Allen key into the
To prevent personal injury,
always disconnect the
Fig. 9g
Plastic Loop
Wingnut
Allen Key
Fig. 9h
Foldable Table
Extension
-26-
Storage
Port
Lock levers
Table Lock
Blade
Wrench