Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Saw will not start
Blade does not
come up to
speed
Excessive vibra-
tion
Cut binds, burns,
stalls motor when
ripping
Cut not true at
90° or 45° posi-
tions
Plastic melts or
blade tips over-
heat when cut-
ting.
TROUBLESHOOTING
CAUSE
Battery pack is not attached.
•
Power adapter is not connected to
•
power outlet.
Cord of the power adapter is
•
damaged.
Other
•
Battery pack has low charge level.
•
The battery pack is near the end
•
of its life.
The battery pack, power adapter,
•
or saw is overheated.
Bevel lock handle is not tightened.
•
Blade out of balance.
•
Arbor nut is loose.
•
Saw is not mounted securely to
•
stand or workbench.
The blade is dull.
•
Warped workpiece.
•
Rip fence is not parallel to the
•
blade.
The riving knife is out of
•
alignment.
Alignment screws not adjusted
•
properly.
Feed rate is too high.
•
Blade tips are dull.
•
Connect the battery pack.
•
Make sure that the battery pack is fully
inserted.
Connect the power adapter to power
•
outlet.
Please contact customer service
•
or an authorized service center for
assistance.
Have the saw reviewed by a FLEX
•
Factory Service Center or Authorized
FLEX Service Station
Charge the battery pack.
•
Replace the battery pack.
•
Allow the battery pack, power adapter,
•
or saw to cool down until it reaches
normal operating temperature.
Tighten the bevel lock handle.
•
Discard the blade and use a different
•
blade.
See chapter "TO CHANGE THE
•
BLADE"
Tighten all mounting hardware.
•
Replace with a new blade.
•
Make sure the concave or hollow side
•
of the workpiece is facing DOWN, and
feed slowly.
See chapter "ALIGNING RIP FENCE".
•
See chapter "RIVING KNIFE
•
ALIGNMENT".
See chapter "ADJUST THE BLADE
•
PARALLEL TO THE MITER GAUGE
SLOTS".
Reduce the feed rate through blade.
•
Sharpen the tips or replace the blade.
•
-53-
SOLUTION
Publicidad
