Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
LEARNING PROCESS
IMPORTANT: This fan has been pre-paired
at the factory and the fan can be used now. If
you have two or more fans, please follow steps
below to control each fan independently. Also
follow steps below to re-pair the remote and the
receiver when needed.
NOTE: The dip switch in the battery
compartment has been set on "0" position for
your convenience. If you want to re-pair the
remote, please set the dip switch on "1" position.
To add a remote to your fan's memory, use the
steps below:
Ensure AC power to the fan is OFF to begin the
learning process.
Slide the dip switch in the battery compartment
to the "1" position.
Turn the fan's AC power ON.
Within 30 seconds of turning AC power on, press
and release the "LEARN" button located in the
remote's battery compartment to enter the learning
function. The fan blades will start to spin.
The fan will now accept commands from the
added remote.
If you would like to set the dip switch back to the
"0" position after a learning, please re-pair the
remote by following the learning process again.
NOTE: If installing multiple fans on separate
remotes, only the fan being programmed should
have AC power turned ON. All other fans, even if
they have already been programmed, should
have AC power OFF so they do not memorize
other remotes during the learning process.
Separate the fan power switches by
approximately 2 meters.
2
LEARN
Remote
Control
17
Publicidad
