Publicidad
Idiomas disponibles
Idiomas disponibles
FAN INSTALLATION
Insert downrod (D) through canopy (B),
4.
canopy bottom cover (C) and coupling cover
(E) Thread wires from fan motor assembly (F)
up through downrod (D).
Slip downrod (D) into collar, align holes and
5.
re-install clevis pin and cotter pin. Tighten set
screws in collar.
6.
Carefully lift the fan motor assembly (F) up to
the mounting bracket (A) and seat the
downrod (D) in the mounting bracket (A)
socket. Make sure the tab on the mounting
bracket (A) socket is properly seated in the
groove in the downrod (D). This will help to
balance the ceiling fan.
Secure the safety cable to the building
structure that independent to the outlet box
using safety cable screw, lock washer and flat
washer (CC) (included). The safety cable
should be in a stress-free state after
installation.
DANGER: Failure to align slot in ball with
tab may cause the fan to wobble or fall, which
could result in serious injury or death.
Hardware Used
Safety Cable Screw,
Lock Washer and
Flat Washer
4
5
Collar
Cotter Pin
Set Screw
6
Safety
cable
x 1
9
Set Screw
Clevis Pin
Tab
Slot
Publicidad
