SKF FlowMaster II Manual De Instrucciones página 5

Safety *
The assembly must be installed, maintained
and repaired exclusively by persons familiar
with the instructions.
Always disconnect power source
(electricity, air or hydraulic) from the
equipment when it is not being used.
This equipment generates high pressure.
Extreme caution should be used when
operating this equipment as material leaks
from loose or ruptured components can
inject fluid through the skin and into the
body. If any fluid appears to penetrate the
skin, seek attention from a doctor
immediately. Do not treat injury as a simple
cut. Tell attending doctor exactly what type of
fluid was injected.
Any other use not in accordance with
instructions will result in loss of claim for
warranty or liability.
• Do not misuse, over-pressurize, modify
parts, use incompatible chemicals, fluids,
or use worn and/or damaged parts.
• Always read and follow the manufacturer's
recommendations regarding fluid
compatibility, and the use of protective
clothing and equipment.
• Failure to comply may result in personal
injury and/or damage to equipment.
Explanation of signal
words for safety
NOTE
Emphasizes useful hints and
recommendations as well as
information to prevent property damage
and ensure efficient trouble-free
operation.
CAUTION

Indicates a dangerous situation that can
lead to light personal injury if
precautionary measures are ignored.
* Indicates change.
WARNING

Indicates a dangerous situation that
could lead to death or serious injury if
precautionary measures are ignored.
DANGER

Indicates a dangerous situation that will
lead to death or serious injury if
precautionary measures are ignored.
WARNING

Do not operate equipment
without reading and fully
understanding safety
warnings and instructions.
Failure to comply may result in death
or serious personal injury.
CAUTION

Do not operate equipment without
wearing personal protective gear.
Wear eye protection. Protective
equipment such as dust mask, non-skid
safety shoes, hard hat, or hearing pro-
tection used for appropriate conditions
will reduce personal injuries.
Failure to comply may result in light
personal injury.
WARNING

Do not allow any body part
to be trapped by equipment.
Body parts can be crushed
by subassemblies during
operation.
Failure to comply may result in death
or serious physical injury.
WARNING

Do not allow fluid to leak
onto floor when operating
equipment. If spill occurs,
clean any fluid on floor before continuing
operation.
Failure to comply may result in death
or serious personal injury.
5
WARNING

Do not use this equipment to supply,
transport, or store hazardous
substances and mixtures in accordance
with annex I part 2-5 of the CLP
regulation (EG 1272/2008) or HCS 29
CFR 1910.1200 marked with GHS01,
GHS06 and GHS08 hazard pictograms
shown:
Failure to comply may result in death
or serious personal injury.
WARNING

Do not exceed the stated
maximum working
pressure of the equipment
or of the lowest rated
component in your system.
Use extreme caution when operating
equipment as equipment generates
very high grease pressure.
Failure to comply may result in death
or serious personal injury.
WARNING

Do not leave attached to
power supplies when
performing maintenance or
service, disconnect all
hydraulic and electric power to pump
assembly.
Failure to comply may result in death
or serious personal injury.
WARNING

Do not exceed maximum
rated outlet pressure. Pump
is not equipped with high
pressure shut-off valve.
Failure to comply may result in personal
injury and/or damage to equipment.
Failure to comply may result in death
or serious personal injury.