SKF FlowMaster II Manual De Instrucciones página 9

Install pump
Pump was tested in lightweight oil left in to
protect pump from corrosion. Flush pump
before connecting to system to prevent
contamination of grease with residual oil.
1 Mount pump securely on drum cover so it
cannot move or vibrate during operation.
Refer to Fig. 3.
2 Connect material supply line to
pump outlet (55).
3 Install safety unloader (77) in open outlet
port.
DANGER

Do not connect electrical wiring prior to
performing lock out/tag out system.
Failure to comply will result in death,
severe personal injury and/or damage
to equipment.
37
77
4 Install high pressure shut-off valve in
material supply line (required).
5 Refer to Fig. 1, page 7 to wire pump
motor and vent valve (if used).
6 Fuse motor as recommended in table
( ).
† Model 85752
7 Connect power to motor leads.
NOTE
If necessary to drill mounting holes into
reservoir cover, refer to Fig. 2, page 8
for hole pattern and dimensions.
Fig. 3
55
9
Model 85752
12 V 19:1 gear ratio, 2 stage
Back pressure Current
psi (bar) rpm A
0 (0) 105 2.0
1 000 (68) 103 4.0
2 000 (137) 101 5.9
3 000 (206) 99 7.4
4 000 (275) 55.9 9.7
5 000 (344) 55.4 13.0
1) Fuse for 20 A.
1)