Publicidad
Stance Adjustment
SYMPTOM
Not enough flexion
Too much flexion
SWING PHASE
Flexion Resistance
SYMPTOM
Flexion too fast or
Excessive heel rise
Flexion too slow or
Heel rise not sufficient
Extension Resistance
SYMPTOM
Extension too fast or
Impact too abrupt
Extension too slow or
Not sufficient
WARNING
Flexion and extension must be possible at all settings.
▪
Avoid pinching hazards! Do not place fingers near the flexing area of the knee.
▪
Patient concerns about the function should be reported to the prosthetist
▪
immediately, including but not limited to: noise, sudden loss of function, brake
release sticking, etc.
Do not disassemble the knee. Contact College Park to arrange a repair or replacement.
▪
Do not expose this product to moisture, i.e. fresh water, corrosive materials, salt water
▪
or pH extremes. If the knee encounters moisture, wipe it dry using a lint-free cloth.
Contaminants such as dirt and the use of lubricants or powder may affect the
▪
function of the knee brake and lead to failure.
Do not use compressed air to clean the knee as it can push dirt inside of the knee.
▪
Failure to follow these technical instructions or use of this product outside the scope
▪
of its Limited Warranty may result in injury to the patient or damage to the product.
DESIRED RESULT
Increase Stance Flexion
Decrease Stance Flexion
DESIRED RESULT
Increase Resistance
(close valve)
Decrease Resistance
(open valve)
DESIRED RESULT
Increase Resistance
(close valve)
Decrease Resistance
(open valve)
SCREW
ADJUSTMENT
S
Turn
counterclockwise
S
Turn
clockwise
SCREW
ADJUSTMENT
F
Turn
clockwise
F
Turn
counterclockwise
SCREW
ADJUSTMENT
E
Turn
clockwise
E
Turn
counterclockwise
EN
Publicidad
