WARRANTY INSPECTION AND
MAINTENANCE INFORMATION
EN
College Park recommends that you schedule your patients for check-ups per the
warranty inspection schedule below.
High patient weight or activity level may require more frequent inspections. We recommend
you visually inspect the following applicable parts for excessive wear and fatigue at each
warranty inspection.
▪ Knee Assembly, Extension Stop Bumpers
Warranty inspection schedule for College Park Victor: Six months, then annually.
TECHNICAL ASSISTANCE /
EMERGENCY SERVICE 24-7-365
College Park's regular office hours are Monday through Friday, 8:30 am – 5:30 pm
(EST). After hours, an emergency Technical Service number is available to contact a
College Park representative.
LIABILITY
The manufacturer is not liable for damage caused by component combinations that were
not authorized by the manufacturer
CAUTION
College Park products and components are designed and tested according to the
applicable official standards or an in-house defined standard when no official standard
applies. Compatibility and compliance with these standards are achieved only when
College Park products are used with other recommended College Park components.
This product has been designed and tested based on single patient usage. This device
should NOT be used by multiple patients.
CAUTION
If any problems occur with the use of this product, immediately contact your medical
professional. The prosthetist and/or patient should report any serious incident* that has
occurred in relation to the device to College Park Industries, Inc. and the competent
authority of the Member State in which the prosthetist and/or patient is established.
*'Serious incident' is defined as any incident that directly or indirectly led, may have led,
or might lead to any of the following; (a) the death of a patient, user, or other person, (b)
the temporary or permanent serious deterioration of a patient's, user's, or other person's
state of health, (c) a serious public health threat.
COMPLIANCE
This device has been tested according to ISO 10328 standard to three million load
cycles. Depending on patient activity this may correspond to 3-5 years of use.
ISO 10328 - LABEL
WEIGHT LIMIT (KG)
125
ISO 10328 - "P" - "m"kg*)
*) Body mass limit not to be exceeded!
For specific conditions and limitations of use, see intended
use section of manufacturer's written instructions.
LABEL TEXT
ISO 10328-P6-125 kg