Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the Cutting Burrs
If the cutting burrs are damaged, or
have reached the end of their life
(usually after grinding 270–360 kg of
coffee), they can be replaced easily.
Refer to "Service Centers" on page 19
to order a set of replacement burrs.
To Replace the Burrs:
1. Remove the faceplate and burr-
shaft assemblies. For instructions,
see "Cleaning the Cutting Burrs"
steps 1, 2, and 3 on page 14.
2. With a screwdriver, remove the
burr from the burr-shaft assembly
by turning the two burr-mounting
screws counter-clockwise until free.
Care and Cleaning
3. Remove the burr from the motor
4. Attach the replacement burrs to
5. Insert the burr-shaft assembly into
17
housing by turning the two
burr-mounting screws
counter-clockwise until free.
the burr-shaft assembly and motor
housing using the burr-mounting
screws. Make certain the cutting
surfaces of the burrs face
outward, and the burr-mounting
screws are tight.
the motor housing and attach the
faceplate assembly. For
instructions, see "Cleaning the
Cutting Burrs" steps 5–10 on
pages 15 and 16.
Publicidad
