Hayward PROChem Double pH/ORP Manual Del Propietário página 10

EN
7. Screw the terminal cap clockwise until it is corectly fixed
on the body of the sensor.
8. Insert the sensor in the tightening nut of the probe hold-
er and then in the plexi probe holder.
Very important
After installing the probe in the plexi probe holder, wait at least 3 hours before the calibration procedure, in
order to allow the sensor to polarize.
4a. Electrical installation and wiring
Connect the ProChem Double to a permanent power outlet.
Open the peristaltic pump lid (1), unscrew four screws (2) and pull the peristaltic pump on the side (3), as illustrated in the
pictures below:
4. ELECTRICAL CONNECTIONS

ProChem Double | pH · ORP · Chlorine
Only use spare parts supplied by Hayward brands ®

Page 9 on 42