your heat-resistant container under the steam nozzle.
Turn the controller up again briefly so that the milk res-
idue is rinsed out of the steam nozzle. Wipe the steam
nozzle with a damp cloth.
12. You switch off the steam function by pressing the
button. The indicator light on the button goes out and
the other two indicator lights for the cups light up.
Use of Nespresso Compatible Capsules
The appliance can also be used with Nespresso compatible
capsules.
1. Fill the water tank with sufficient water and reinsert it.
The water level must be between the MIN and MAX
marks.
2. Switch on the appliance. A beep sounds. The indicator
light of the
button lights up while the two indicator
lights of the cups flash. The appliance starts heating.
The heating plate becomes hot.
3. If you have previously frothed milk, release all pressure
from the appliance:
3.1 When the indicator light of the
press this button to switch off the function. Also
make sure that the controller is set to .
3.2 Place a suitable vessel under the steam nozzle.
3.3 Set the controller to position until no more steam
comes.
3.4 Turn the controller back to position .
4. Insert a Nespresso compatible capsule into the capsule
adapter. To do this, proceed as follows:
4.1 Open the flap on the capsule adapter.
4.2 Press the capsule into the adapter with light pres-
sure. The metal tips at the bottom of the adapter
pierce the capsule.
4.3 Close the flap again so that it audibly clicks into
place.
5. Insert the adapter for the capsules into the filter holder.
6. Fit the filter holder to the brew head. Make sure that the
filter holder is firmly seated in the brew head.
WARNING:
• Always pull the mains plug out of the socket before cleaning
and wait until the appliance has cooled down.
• Do not immerse the appliance in water. It could cause an elec-
tric shock or fire.
• The steam nozzle is hot immediately after use!
PC-ES1265_IM
7. When the required brewing temperature is reached, two
beeps sound and the indicator lights of the cups light up.
Place the cup(s) under the brew head on the drip tray.
8. Press the
through the filter.
9. When no more coffee flows, remove the cup(s).
- Remove the filter holder after each preparation. This
prolongs the life of the rubber seal in the brew head.
10. Detach the filter holder from the brew head.
11. To prepare another cup, the capsule must be replaced
with a new capsule:
The metal parts on the filter holder and the filter insert
are hot.
Before you can change the capsule, you must cool the
adapter for Nespresso compatible capsules under cold
water.
12. To prepare the next cup(s), proceed as described above.
- The coffee temperature of the first cup prepared and
button is on,
the following cup(s) may be different.
Hot Water Function
The appliance can also be used to prepare hot water for
tea. To do this, proceed as follows:
1. Fill the water tank with sufficient water and reinsert it.
2. Swivel the steam pipe outwards. Make sure that the
steam nozzle is screwed on.
3. Place a cup under the steam nozzle.
4. Switch on the appliance with the
two indicator lights of the cups light up.
5. Turn the controller to the position . And then press the
or
6. When the appropriate amount of water for one or two
cups has been dispensed, return the controller to the
position .
Cleaning
or
button. The hot water is pressed
WARNING: Risk of Burns!
button. Wait until the
button.
19
09.11.23